Home › Texas › High Plains › Briscoe County

Briscoe County · High Plains

Foundation Repair in Briscoe County, TX

Foundation repair in Briscoe County, TX depends a lot on which side of the Caprock the house sits on. Silverton and the farms around it are on the High Plains, where Pullman clay loam hides a swelling subsoil, while the land below the escarpment is sandy, loamy breaks country. Almost half the county’s homes predate 1960, so worn piers and old plumbing show up alongside the soil questions.

Get a free foundation inspection

Tell us what you’re seeing. We’ll call you back, usually the same business day.

Repairs are performed by independent, vetted partner contractors. Your details go only to the one contractor we match you with.

The short answer

What causes foundation trouble in Briscoe County?

Two different grounds. Above the Caprock, Pullman’s clay subsoil swells after soaking rains and shrinks in drought. Below it, low-swell soils like Quinlan and Burson erode instead. About 22 inches of rain falls in Silverton in a normal year, and about 44% of homes were built before 1960.

Reviewed by

Brad Stevens

Owner, Texas Tough Foundation Repair · 20 years in Texas foundation repair · Updated November 2026

Above and below the Caprock

About 42% of Briscoe County is High Plains and 58% is Southwestern Tablelands, the cut-down country below the escarpment. Pullman covers about 27% of the county and rates moderate overall, but its clay layer rates high, so the high-swell share climbs from about 7% to about 39% when soils are judged by their worst layer. Olton, about 5%, behaves the same way.

Below the Caprock, Quinlan and Burson each cover about 12%. Both are low-swell soils with a plasticity index near 11, and riverwash and rock outcrop show up along the draws. On that ground, a slab is more likely to lose support to erosion on a slope than to clay heave. The rain figure comes from Silverton itself, which gives it more weight than most rural stations.

Soil card · Briscoe County

High-swell ground

7%

of county land in high or very high shrink-swell soils; 39% when the clay subsoil layer alone is counted

Annual rain

21.7 in

NOAA 1991–2020 normal, Silverton

Dominant soil

Pullman

plasticity index 26

Pullman

27% of the county · plasticity index 26

Moderate swell

Quinlan

12% of the county · plasticity index 11

Low swell

Burson

12% of the county · plasticity index 11

Low swell

Olton

5% of the county · plasticity index 25

Moderate swell

Sources: USDA NRCS Soil Survey (SSURGO), NOAA climate normals. How we use this data

Homes by age · Briscoe County

Median home built 1963

Built before 1960

44%

Built 1960–1979

39%

Built 1980–1999

9%

Built 2000 or later

7%

Source: U.S. Census Bureau, American Community Survey 5-year estimates.

A county of older homes

About 44% of Briscoe County’s roughly 850 homes were built before 1960 and another 39% between 1960 and 1979. The median is 1963, and fewer than one in ten homes is from 1980 to 1999. With a housing count this small, the shares carry a fair margin of error, but the age is not in doubt.

Raised floors on wood or block piers were standard for much of that era. If your house is one of them, a sagging beam or a soft spot in the floor is a crawl space problem first. The fix is re-shimming, new piers and sometimes beam repair, as covered under pier and beam repair.

Finding foundation repair help in Briscoe County

A search for foundation repair in Briscoe County returns a few local results and several directories. That is common out here. Partner coverage in rural counties varies, and Texas Tough will tell you straight whether a vetted partner contractor works around Silverton before anyone makes the drive.

If a partner does, the free inspection should include floor elevation readings and a crawl space check on a raised house. On a Pullman lot, slab piers go through the clay subsoil to firmer ground, and the estimate should include drainage. On a sloped lot below the Caprock, grading to stop erosion may matter more than piers.

For price, use the statewide figures: a few piers often run $3,300 to $7,000 and a moderate repair about $4,000 to $6,000. More in the cost guide.

Common signs in Briscoe County homes

The Texas Tough Method

How Texas Tough works with you

01

Tell us what you're seeing

Call or send photos. We help sort cosmetic from structural first.

02

Free, no-pressure inspection

A vetted local partner measures the house and writes up an estimate.

03

Read the estimate with us

Pier count, pier type, drainage and warranty terms in plain English.

04

Repair and follow-up

Pier work carries a lifetime transferable warranty, and we check in afterward.

Repairs are performed by independent, vetted partner contractors. How it works

Questions locals ask

Briscoe County foundation repair FAQ

The plain around Silverton is mostly Pullman clay loam, which has a clay subsoil rated high for shrink-swell. Below the Caprock, soils like Quinlan and Burson rate low. So it depends on where your house sits.

Many of the older ones are. About 44% of homes predate 1960. Check for a crawl space vent around the base of the house. If you have one, the repair usually starts underneath, not with slab piers.

Statewide, a pier and beam re-level usually runs $5,000 to $15,000. Re-shimming sits at the low end. Replacing rotted piers or beams under a 1950s farmhouse pushes it higher. Get the scope in writing.

Work can happen any time. On Pullman clay, many contractors prefer not to level right after the late-spring storms or at the end of a dry summer, when the subsoil is at an extreme. Don’t let a serious problem wait for the calendar.

Not sure if it's serious?

In Briscoe County? Call before you guess.

Tell Texas Tough what you’re seeing and if the house is on the plain or below the Caprock. We’ll say if it sounds minor, and if it doesn’t, we’ll tell you whether a vetted partner covers your area and arrange a free, no-pressure inspection. Repairs are performed by independent, vetted partner contractors.