Home › Texas › High Plains › Parmer County
Parmer County · High Plains
Foundation Repair in Parmer County, TX
Foundation repair in Parmer County, TX centers on Olton clay loam, which covers about 43% of this flat county on the New Mexico line, more than in any neighboring county. Olton’s clay layer rates high for shrink-swell, and with Pullman added, about 57% of the county is high-swell by worst layer. Most homes went up between 1960 and 1979, and many sit on slabs that have cycled with the clay for decades.
Typical cost
About $3,300 – $7,000 for a few piers, $300 – $800 to seal cracks. Texas ranges; see costs.
The ground here
2% of Parmer County is high-swell ground. The most common soil in the county is Olton.
Who does the work
One vetted, independent partner contractor who works around Parmer County. Your details go to that company only.
How long it takes
The free inspection takes about an hour. Most pier jobs take 1 to 3 days.
Get a free foundation inspection
Tell us what you’re seeing. We’ll call you back, usually the same business day.
Repairs are performed by independent, vetted partner contractors. Your details go only to the one contractor we match you with.
Why Parmer County homeowners start here
Four things you get on every request.
Free written estimate
A vetted partner inspects the house and puts the pier count, pier type and price in writing. No charge and no pressure.
Lifetime transferable warranty
Partner pier work carries a lifetime warranty that transfers to the next owner when you sell.
One vetted local contractor
We match you with one independent, vetted partner contractor near you. Your details go to that company only.
20 years in Texas foundation repair
Guides written and reviewed by owner Brad Stevens, who has worked in Texas foundation repair for 20 years.
The short answer
Why do Parmer County foundations move?
Olton, the leading soil at about 43% of the county, has a clay subsoil rated high for shrink-swell, and Pullman, about 13%, behaves the same way. About 57% of the county is high-swell by worst layer. Rain averages about 19 inches, mostly in summer storms.
Reviewed by
Brad Stevens
Owner, Texas Tough Foundation Repair · 20 years in Texas foundation repair · Updated November 2026
Olton clay along the state line
Parmer County is entirely High Plains. Olton clay loam covers about 43% of it, with a plasticity index around 25. Its full profile rates moderate, but its clay layer rates high. Pullman, about 13%, is similar. Acuff, about 17%, and Amarillo, about 7%, are low-swell loams, and Estacado rates moderate.
So the card shows only about 2% high-swell, while the worst-layer figure is about 57%. In practice, a house on Olton or Pullman sits on clay a foot or two down that swells when soaked and shrinks in drought. A house on Acuff or Amarillo loam sits on much calmer ground.
The rain figure, about 19 inches, comes from the Friona station, about 25 miles from Farwell but inside the county. Storms on flat ground leave water standing against slabs, and that’s what feeds the clay layer.
Soil card · Parmer County
High-swell ground
2%
of county land in high or very high shrink-swell soils; 57% when the clay subsoil layer alone is counted
Annual rain
19.3 in
NOAA 1991–2020 normal, Friona
Dominant soil
Olton
plasticity index 25
Olton
42% of the county · plasticity index 25
Moderate swell
Acuff
17% of the county · plasticity index 16
Low swell
Pullman
12% of the county · plasticity index 26
Moderate swell
Amarillo
7% of the county · plasticity index 16
Low swell
Sources: USDA NRCS Soil Survey (SSURGO), NOAA climate normals. How we use this data
Homes by age · Parmer County
Median home built 1973
Built before 1960
24%
Built 1960–1979
44%
Built 1980–1999
18%
Built 2000 or later
14%
Source: U.S. Census Bureau, American Community Survey 5-year estimates.
Mostly 1960s and 1970s homes
About 44% of Parmer County’s homes were built between 1960 and 1979 and about 24% before 1960. The median year is 1973, and about 14% are from 2000 or later.
Most homes are slab-on-grade. On Olton clay, 1960s and 1970s slabs show it as brick cracks at corners, doors that bind after storms and gaps that open by late summer. Older raised homes need pier and shim checks. See slab foundation repair.
A crack that opens and closes with the seasons is normal on this clay. One that grows a little wider each year is the one to have measured.
Before and after
What a typical repair looks like
Illustrations of common Texas foundation jobs, not photos of a specific house in Parmer County. Swipe to compare each before with its after.




Repairs and costs in Parmer County
On Olton and Pullman lots, a sound repair pairs piers driven through the clay layer with drainage that moves storm water away. Ask for pier type, count and expected depth in writing.
Use the statewide ranges: about $3,300 to $7,000 for a few piers and $4,000 to $6,000 for a typical moderate repair. See the cost guide.
An honest note: when we searched for foundation repair in Parmer County, no local company showed up. The results were mostly companies based in other parts of Texas. Texas Tough will tell you straight whether a vetted partner contractor works around Farwell or Friona before you wait on anyone. Next door is Castro County.
Signs to watch on Olton clay
- Brick cracks that widen in late summer
- Doors that stick after a run of storms
- Gaps between the slab and garage door
- A slab corner low beside a downspout
- Cracks that close up again after rain
Costs
What foundation repair costs around Parmer County
These are typical Texas ranges, not a quote for Parmer County. Your price depends on the house, and every estimate from a partner contractor is written and itemized.

Sealing hairline cracks
Typical cost in Texas: $300 – $800
Statewide Texas range, updated November 2026.

Partial settlement, a few piers
Typical cost in Texas: $3,300 – $7,000
Statewide Texas range, updated November 2026.

Pier and beam re-leveling
Typical cost in Texas: $5,000 – $15,000
Statewide Texas range, updated November 2026.
What changes the price
- How many piers the house needs, and where
- Pier type: pressed concrete, steel or drilled bell-bottom
- How deep the piers go to reach stable soil
- Drainage work added to the repair
- Access: crawl space height, landscaping, interior slab breakouts
- Plumbing tests and an engineer report, if needed

From homeowners elsewhere in Texas
What homeowners said
Real customers matched with a partner contractor through Texas Tough, quoted as written.
“My wife and I had two foundation estimates and couldn’t tell why they were so far apart. Texas Tough walked us through where each pier would go and what it would support. That drawing made the decision a lot easier.”
Joel
Katy, TX · Foundation repair
“I asked how the repaired area would look because it’s right beside our front entrance. They were upfront that fresh material would be a slightly different shade. The edges came out neat, and the finished patch looked like what we’d discussed.”
Omar
Carrollton, TX · Foundation crack repair
The Texas Tough Method
How Texas Tough works with you
01
Tell us what you're seeing
Call or send photos. We help sort cosmetic from structural first.
02
Free, no-pressure inspection
A vetted local partner measures the house and writes up an estimate.
03
Read the estimate with us
Pier count, pier type, drainage and warranty terms in plain English.
04
Repair and follow-up
Pier work carries a lifetime transferable warranty, and we check in afterward.
Repairs are performed by independent, vetted partner contractors. How it works
Questions locals ask
Parmer County foundation repair FAQ
Is the soil in Parmer County expansive?
Below the surface, much of it is. Olton covers about 43% of the county and its clay layer rates high. About 57% of Parmer County is high-swell by worst layer.
Why does my Farwell house crack in summer and close in spring?
That’s the clay layer drying and shrinking in hot, dry months, then swelling back after rain. It’s typical on Olton and Pullman soils. If the cracks keep growing year to year, have it inspected.
Is it good to water your foundation in Texas?
On Olton clay, steady moisture in a long dry spell can limit shrinkage. Use a soaker hose a foot or two out from the slab, don’t let water pool, and stop when the rain returns.
How much does a foundation inspection cost in Texas?
Inspections arranged through Texas Tough cost you nothing and end with a written estimate. If you want an independent structural engineer’s opinion on an Olton clay lot, expect roughly $500 to $1,200.
Not sure if it's serious?
In Parmer County? Ask before you worry.
Call Texas Tough and tell us what you’re seeing. If it’s minor, we’ll say so. If it isn’t, we’ll tell you whether a vetted partner covers your area and set up a free, no-pressure inspection. Repairs are performed by independent, vetted partner contractors.